Supermicro Motherboard X10 and x11
X10DRW-i
Please make sure the following settings are correct:
1. Please make sure all cores are enabled:
Advanced >> CPU Configuration >> Core enabled >> “0” to enable all cores.
2. Under the Bios setup go to:
Advanced >> CPU Configuration >> Advanced Power Management
and make sure the setting are as follows:
Power Technology >> Custom Energy performance Tuning >> disable Energy performance BIAS setting >> performance Energy efficient turbo >> disable
3. Then go to
Advanced >> CPU Configuration >> Advanced Power Management >> CPU P state control
and make sure the settings are as follows
EIST (P-States) >> Enable Turbo mode >> enable P-state coordination >> HW_ALL
4. Then
Advanced >> CPU Configuration >> Advanced Power Management >> CPU C state control
Advanced >> CPU Configuration >> Advanced Power Management >> CPU C state control
and make sure the setting are as follows.
Package C-state limit >> C0/C1 state CPU C3 Report >>disable CPU C6 report >> enable Enhanced Halt state >> disable
https://www.supermicro.com/support/faqs/faq.cfm?faq=21555